Description: 2-1/2” off-road X-pipe for 1994-1995 Mustang 5.0L both LX and GT.
OFF-ROAD RACE USE ONLY!! This product is not intended for use on public roads.
Instructions:
DO NOT TIGHTEN ANY BOLTS OR CLAMPS UNTIL THE LAST STEP!!
1) Remove the oxygen sensors and the air tube (at the clamp before the air tube splits to the two sides) from the original H-pipe. You will need to remove the air tube mount on the vehicle to the original H-pipe, and disconnect the factory hanger for both sides. Remove the original H-pipe from the car, unbolting the system at the manifolds (or factory shorty-headers) and at the flanges at the middle of the vehicle. Leave the existing rear extension pipes, mufflers and tail pipes in place unless you will be installing another replacement system.
NOTE: you will need to re-use the manifold studs and nuts, and also the original air tube clamp, to install this system. Hardware is included for bolting the rear of the system to your existing exhaust system.
2) Install the driver’s side of the X-pipe (left front section) to the driver’s side manifold, using the original hardware.
3) Repeat step 2) for the passenger side pipe.
4) Install the rear section X-pipe to the front sections, using 2-1/2” clamps.
5) Connect the rear flanged sections of the rear section X-pipe to the existing rear exhaust system using the 3/8” x 2-1/2” bolts, nuts, lock washers, and two fender washers per bolt hole on the flanges.
6) Install the oxygen sensors to the appropriate oxygen sensor nut of each front section. Attach the air tube from the vehicle to the air tube on the X-pipe re-using the original air tube clamp.
7) Tighten all clamps and bolts. Check for clearance, leaks and rattles.
KIT CONTENTS:
2) 2-1/2” clamps 1) left front section
4) 3/8” x 2-1/2” bolts 1) right front section
4) 3/8” nuts 1) rear section X-pipe
4) 3/8” lock washers
8) fender washers
DANGER WARNING: Should the purchaser decide to install this exhaust product at home, be warned that pleasure car or light duty truck/van “bumper” jacks are intended for emergency use only. The use of frame contact jack stands in conjunction with a floor jack as main support is highly recommended to minimize accidental dropping of a vehicle while the installation proceeds.
Limitation
of
liability--Disclaimers: The regulation of emissions production, noise
levels and safety standards is undertaken by the federal government,
each of
the fifty state legislatures, and by many local municipalities, towns
and
counties.
The manufacturer makes no warranties of
merchantability, of fitness for a particular purpose, or that its
products are
approved for general use, or that its products comply with laws,
regulations or
ordinances in the states where they may be sold to the ultimate
purchaser, the
consumer.
The entire risk as to the conformity of this product
in any such state and as to repair, should the product prove to be
defective or
non-conforming, is on the retail purchaser, the buyer, the ultimate
consumer of
such product and it is not upon the seller, distributor, or
manufacturer.
In this connection, retail purchaser, the buyer, the
ultimate consumer assumes the burden of the entire cost of any and all
necessary service, alterations, and or repair.
The foregoing statement limits the liability of the manufacturer.